Zyphht Construction
This shot shows the PCB layouts and other equipment. The main board is the Mini ITX processor, below it is the laptop drive mounted on edge.
I have a USB Wireless N card (upper left plugged directly into the MoBo), and in the usb port I have a Gyration dongle for wireless KB and an "air mouse". (that damn thing was pretty useless until now - I use it a lot for Zyphht!). On the bottom right you can see the USB hub, with the Gytation Dongle plugged into it.
To the right you can see the HC11 processor and the terminal strips I use to connect to +5v and +12v rails.
In the upper right of the photo you can see a USB Webcam, mounted directly to the upright stanchion, but it is there for convienience sake only. Once I put the top deck on, I plan to use a full pan and tilt camera up there, controlled by one of the basic stamps, or possibly the RHVE controller, depending on where I place the video processing.
The underside of the top shelf (not shown), is where the basic stamp boards and the RHVE processor are mounted. Coupling these two shelves are 5v.12v and a single serial cable.
